Router R-1 is configured for BGP routing as shown below: router bgp 65300network 27.0.0.0neighbor 192.23.1.1 remote-as 65300 From the perspective of router R-1, what kind of router is the router with IP address 192.23.1.1?()
Refer to the exhibit. BGP-4 routing to the Internet,in normal behavior,may create asymmetrical routing for different prefixes. The BGP routing table indicates that traffic should follow the paths indicated in the exhibit,but packets are not going further than the border router in AS 4. What could be the cause of this problem?()
In JUNOS software, which is the only BGP attribute where a higher value is preferred?()
BGP Administrative distance?
Two routers configured to run BGP have been connected to a firewall, one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer, including the correctBGP session endpoint addresses and the correct BGP session hop-count limit EBGP multihop. What is agood first test to see if BGP will work across the firewall?()
What does a BGP route reflector do when reflecting a route?()
在①EIGRP汇总;②内部EIGRP;③外部EIGRP;④内部BGP;⑤外部BGP中,管理距离排列顺数正确的是()
Which two statements about the bgp deterministic-med and bgp always-compare-med commands are true?()
In JUNOS software, what is the only BGP attribute where a higher value is preferred?()
Two routers configured to run BGP have been connected to a firewall, one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer, including the correct BGP session endpoint addresses and the correct BGP session hop-count limit (EBGP multihop). What is a good first test to see if BGP will work across the firewall? ()