Refer to the exhibit. MPLS has been configured on all routers in the domain. In order for R2 and R3 to forward frames between them with label headers, what additional configuration will be required on devices that are attached to the LAN segment?()
Refer to the exhibit diagram and configuration. RTB is summarizing its networks from AS 64100with the aggregate-address command. However, the show ip route command on RTA reveals theRTB individual networks as well as its summary route. Which option would ensure that only thesummary route would appear in the routing table of RTA?()
Refer to the exhibit. The network shown in the diagram is experiencing connectivity problems. Which of the following will correct the problems? ()
Refer to the exhibit. A junior network administrator was given the task of configuring port security on SwitchA to allow only PC_A to access the switched network through port fa0/1. If any other device is detected, the port is to drop frames from this device. The administrator configured the interface and tested it with successful pings from PC_A to RouterA, and then observes the output from these two show commands.Which two of these changes are necessary for SwitchA to meet the requirements? ()
Refer to the show interface Gi0/1 switchport command output shown in the exhibit. Which twostatements are true about this interface?()
Refer to the exhibit. Routers A and B are directly connected. Given the configuration, how many EIGRP routes will router B see in its routing table?()
Refer to the exhibit. How will interface FastEthernnet0/1 respond when an 802.1x-enabled client connects to the port? ()
Refer to the exibit .An attempt to deny web access to a subnet blocks all traffic from the subnet.Which interface command immedicately removes the effect of ACL 102?()
Refer to the exhibit. OSPF has been configured on all routers in the network and Area 1 has been configured as a NSSA. Which statement is true about the NSSA Area 1?()
Refer to the exhibit. You have noticed that several users in the network are consuming a great deal of bandwidth for the peer-to-peer application Kazaa2. You would like to limit this traffic, and at the same time provide a guaranteed 100 kb/s bandwidth for one of your servers. After applying the configuration in the exhibit, you notice no change in the bandwidth utilization on the serial link; it is still heavily oversubscribing the interface. What is the cause of this problem? ()